Application | Dosage | Method |
Dry Application : Applied alone or in combination with seed or fertilizers | ||
For Large Application | The soil needs to be thoroughly watered after treating with TRUE HYDROGEL. Around 50-150 grams of the TRUE HYDROGEL can also be used on new or seeded turf by using sower machines. | |
a)Potting Soil | 2 – 5 kgs /m3 | |
b)Backfill Around Trees | ||
c)Shrubs | ||
For Small Application | ||
a)Potting Soil | 5 g for 1L of potting soil | |
Broadcast Application | For broadcast application, the TRUE HYDROGEL is properly mixed and incorporated in the soil at a recommended depth of 4 to 6 inches i.e. 10 to 15 cm before sowing or planting the seed or during fertilizer application. It can be blended with organic fertilizer with a manure spreader or with dry bulk fertilizer with a fertilizer spreader. | |
Banded Application | Using a starter fertilizer row bander TRUE HYDROGEL is applied in the crop or plant furrows alone or blended with dry bulk fertilizer or seed by using side-dress application equipment. It can also be blended with liquid starter fertilizer. Grain drill can also be used in place of row bander but only in low relative humidity environment. Apart from using single operation machines, the TRUE HYDROGEL can also be applied using combined planters and tillage equipment. | |
Green Application | Concentration of 1-3 kg/m3 of substrate before planting | Mix the TRUE HYDROGEL into the plant media at a said concentration of the substrate before planting. Irrigation is required immediately after the planting is done in the container till the soil gets saturated |
Transplant Application | 3 to 40 grams dry granules per tree or shrub transplant. | In this, the TRUE HYDROGEL is mixed with the soil extract or plant substrate. Depending on the root volume, climatic conditions, transplant height, species the application rate varies from 3 to 40 grams dry granules per tree or shrub transplant.
If it is to be done at an individual level, contacting an agronomic technical representative is advised. · Some part of the soil is left untreated for the final coverage of the soil. · The fills material is packed tightly. · The transplants are irrigated until the soil saturates. |
Wet Application : Pre- Hydrated True Hydrogel | ||
It is made by adding TRUE HYDROGEL to water followed by continuous and slow stirring. It can also be added to a stream of water while filling the nurse tank. It is left to swell for about 30 minutes time when the gel is made and ready to use | ||
Potting Soil | 5 g for 1L of potting soil | Certain small plants’ roots and seedlings can be directly dipped into the already prepared TRUE HYDROGEL before the plants are actually planted. Note: But make sure that enough space should be left for planting the plant in the pot or hole as obviously the dry granules when added into water swell up to a size much more than their original size, therefore, keeping a margin of 15% to 20% is a must. |
Transplant Application | Vary from 3 to 40 grams dry granules per tree or shrub transplant. | In this, the TRUE HYDROGEL is mixed with the soil extract or plant substrate. Depending on the root volume, climatic conditions, transplant height, species the application rate varies from 3 to 40 grams dry granules per tree or shrub transplant.
If it is to be done at an individual level, contacting an agronomic technical representative is advised. Method of use: · · Some part of the soil is left untreated for the final coverage of the soil. · The fills material is packed tightly. · The transplants are irrigated until the soil saturates. |
On trees-shrubs-vines ornamentals | Vary from 80 to 400 g dry granulate per plant | Using Injector, the pre-hydrated TRUE HYDROGEL is applied to the roots of the plants. system
The total application rate can vary between 80 – 400 g dry granulate per plant. Penetrates the hard soils with the help of a jackhammer mechanism specifically at depths ranging from 6 to 48 inches (15 – 120 cm) without damaging the roots. Then the air is pressurized into the soil using the injector pulse which helps to create cracks and free space. And then finally, the TRUE HYDROGEL is injected into these newly created spaces. |